Kirchner PRE - series

Systems for monitoring, control and regulation of electroplating and chemical processes also pH control

We offer control and monitoring units for electroplating / chemical processes using ampere hour meter (Ah-meter), temperature control and pH control.

Our devices monitor key physical process parameters and dosing consumable chemistry for electroplating exactly according to consumption. Reduce your quality costs by a more precise process control as you allow by Kirchner PRE. Kirchner PRE can also be easily retrofitted to existing plants.

Kirchner Kirchner PRE 2140

Ampere-hour meter / (A / h) counter for electroplating

Monitoring and metering of wetting agents, leveling agents, brighteners, salts or other additions by counting ampere-hour (A / h-hours). Kirchner PRE helps you to operate electrochemical and galvanic processes with high quality. 

Kirchner ampere-hour meter (A / h counter) can help you with low investment to monitor your electrochemical and galvanic processes and readjust if necessary. Kirchner PRE A/h counters help to reduce quality costs over the years. Learn more here about Kirchner PRE 2140 (ampere-hour meter).

Kirchner PRE 2340

pH monitoring and control system

In many chemical processes and also by electroplating, the pH of the chemical bath have a significant impact on the behavior or on the deposited layer. Thus, even small variations in pH change cause variation in the gloss of nickel layers. 

In electroforming the PH can lead to internal stresses if the pH-value is too far from the desired value.  Kirchner pH control equipment will help you to monitor and to controll these processes in electroplating and chemical industrie to secure and carry. Find out more about Kirchner PRE 2340 (pH control equipment). 

Kirchner PRE 2260

Control device and dosing system  for chemical processes and electrodeposition

In electrodeposition and plating a dosage of process chemicals is necessary depending on flown Ampere-hours. This also effects the pH value in the plating processes so you also have to adjust the pH-value continuously. 

Kirchner PRE (process control system) meets all these requirements. Our process control system continuously measures the actual pH, the temperature of the process and the flowed ampere hours (Ah). 

Through six individually controllable potential-free relay contacts, different chemical additives can be dosed into the plating bath. The dosage is freely configurable by the ampere-hours (Ah) or pH. Kirchner PRE (process control unit) are an ideal combination of an ampere-hour meter and a pH monitor system. It is designed directly to the process control and monitoring of chemical and electroplating processes. Find out more about Kirchner PRE 2260 (Process Monitoring with AH counters and pH regulator).